Wilton 41002 Instrucciones de operaciones

Operating Instructions and Parts Manual Belt and Disc Sander Model 41002 WMH TOOL GROUP 2420 Vantage Drive Elgin, Illinois 60123 Part No.

10Installing Disc Table 1. Position the disc table at an angle, as shown in Figure 3, and slide the table on so that the trunnion slots fit over the

11Grounding Instructions This machine must be grounded while in use to protect the operator from electric shock. In the event of a malfunction or b

12Extension Cords Use proper extension cords. Make sure the cord rating is suitable for the amperage of the machine’s motor. An undersized cord will

134. Tighten both handles securely. To avoid trapping the workpiece or fingers between the table and abrasive disc, the table edge should be posit

14Abrasive Belt Replacement 1. Unplug the Sander from the power source. 2. Unscrew and remove the two knobs on the belt cover. 3. Remove the belt

158. Make further adjustments as needed. 9. Tighten the hex nut to secure the setting. Abrasive Disc Replacement 1. Unplug the sander from the po

16Operation This sander is intended for dry sanding of metals. Do not use lubricants. Do not sand or polish magnesium; it may create a fire hazard.

172. Tighten the miter gauge securely so the miter reference angle will not shift while you are sanding. 3. Place the workpiece against the miter re

18Maintenance Before performing any maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off th

19Troubleshooting Trouble Probable Cause Remedy Not connected to power source. Connect to power source. Branch circuit fuse is blown or the circuit

2 This manual has been prepared for the owner and operators of a Wilton 41002 Belt/Disc Sander. Its purpose, aside from machine operation, is to prom

202x42x8 Belt and Disc Sander

21Parts List for 2x42x8 Belt and Disc Sander Index No. Part No. Description Size Qty 1...41002-01... Base...

2257...TS-1505021 ... Socket Head Cap Screw... M10x20 ...2 58...4100

23

24 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.c

3 Table of Contents Warranty and Service ...

4 Warning 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on t

5 blahblahblah 21. Make your workshop child proof with padlocks, master switches or by removing starter keys. 22. Give your work undivided attention

6 Introduction This manual is provided by WMH Tool Group covering the safe operation and maintenance procedures for a Wilton 2x42x8 Belt and Disc San

7 Features and Terminology

8 Unpacking Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not disca

9 Assembly Tools needed for assembly: • 10mm open-end wrench • Cross-point (Phillips) screwdriver • Combination square, or similar angle measuring